This will allow you to clearly hear feedback announcements or system beeps.ġ. You may find it convenient to adjust the volume setting before entering the Programming Mode. Lynx Plus is not intended for UL985 Household Fire applications unless a 24-hour backup battery (P/N LYNXRCHKIT-HC or LYNXRCHKIT-SHA) is installed. The Installation and Setup Guide contains full descriptions for all data fields. 23 Refer to the Lynx Plus Series Installation and Setup Guide P/N 800-03857 or later for detailed information on programming the system. 22 Lynx Plus Summary of Connections Diagram. 20 5800 Series Transmitter Loop Numbers Diagram. 19 Vocabulary Index (for 684 Assign Zone Voice Descriptors). 16 Powerline Carrier Device Worksheet for 680 and 681. 10 656 Enhanced Zone Programming Worksheet. After exiting the programming mode, the 元000 takes up to one minute to reset.ĭata Fields. Once a selection has been made, enter the star (*) key followed by 99 to exit the programming mode. Select 1 = turn backlighting off after inactivity, 0 = no timeout, to have the backlight always on. This option allows users to program the choice of either always having the backlighting of the keypad on or turning the backlighting off after 10 seconds of keypad inactivity. Press the star (*) followed by 22 (keypad backlight). Once in the Program Modem the data field will display “20 Installer Code” (this is the first data field in the system. The 元000 will display “Entering Programming Mode”. To turn the backlighting off after inactivity, enter programming mode by keying in the installer code (the Honeywell factory default installer code is 4112) followed by 800, without pausing between numbers. The backlight on the Honeywell 元000 (Lynx Plus) cannot be permanently disabled but can be programmed to turn off after inactivity.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |